Replacement Blade for Reeds n Stuff Profiler - 360°

Product number: 1103-00025 Manufacturer:

After years of development, Reeds 'n Stuff is proud to offer the Blade 360°. When the blade becomes dull simply rotate to the next sharp section and continue profiling. This can be done at least 6 times, providing reeds and reeds of profiling before a replacement blade is needed.

The screw holding the blade is easily accessed from the underside, meaning once the height of the blade holder is set, you can set it and forget it. Simply loosen the screw, rotate the blade, and re-tighten the screw. Within seconds you can continue profiling reeds, rather than having to replace the entire blade.

- To rotate the blade, first loosen the screw on the underside of the blade holder with the attached screwdriver.
- Carefully rotate the blade to the next desired position.
- Hold the blade in place while tightening the screw with the provided screwdriver and you are ready to profile.

How often can I rotate the blade before I need a new one?: The Blade 360° can be used in at least six positions. Those who are very careful and precise could potentially use smaller rotations and therefore more positions.
Do I need to purchase a new blade holder with every new Blade 360°?: You only need to purchase the blade holder once. After this only new spare blades need be be purchased, as the holder can be reused.
Does the Blade 360° come with only one screw?: The Blade 360° with blade holder is delivered with several extra screws and the necessary screwdriver to adjust, rotate, and replace the blades. It is also possible to purchase a service set that includes extra screws and a replacement screwdriver.

97,90€ per piece*

Ready for shipping

Manufacturer information
Safety instructions

Reeds ´n Stuff GmbH
09465 Cranzahl
Deutschland
info@reedsnstuff.com

Wearing protective equipment

Always wear cut-resistant gloves and safety goggles when handling the knives to avoid injury.

Transport and storage

Always pack the knives securely and store them separately from other tools to prevent damage or accidents.

Installing the knives

Install the blades carefully and in accordance with the manufacturer's instructions.
Check that the blades are securely fastened and correctly aligned.

Checking before operation

Only use sharp, undamaged blades.
Replace damaged blades immediately.

Disposal of the blades

Dispose of worn or damaged blades safely, e.g. in a suitable container, to avoid cutting injuries.

Caution:Improper handling of these blades can lead to serious injuries. The machine manufacturer's safety instructions must always be observed!